Compaq ML370 No action required. This, Array resuming, Automatic Data Occurs while Automatic Data

Diagnostics and Troubleshooting 3-19

Table 3-2

POST Error Messages continued

Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
1778 - Slot x Drive	None	This message appears whenever	No action required. This
Array resuming		a controller reset or power cycle	message appears whenever a
Automatic Data		occurs while Automatic Data	controller reset or power cycle
Recovery process		Recovery is in progress.	occurs while Automatic Data
			Recovery is in progress.
1779 - Slot x Drive	None	Intermittent drive failure and/or	If this message appears and
Array—replacement		possible loss of data	drive x (identified by its SCSI ID)
drives detected OR			has not been replaced, this
previously failed			indicates an intermittent drive
drive(s) now appear			failure. This message also
to be operational:			appears once immediately
Port (y): SCSI ID (x):			following drive replacement
			whenever data must be restored
Restore data from
			from backup.
backup if
replacement drive x
has been installed.
1780 - Disk 0 Failure	None	Hard drive/format error	Run Diagnostics. Replace failed
			assembly as indicated.
1781 - Disk 1 Failure	None	Hard drive/format error	Run Diagnostics. Replace failed
			assembly as indicated.
1782 - Disk	None	Hard disk drive circuitry error	Run Diagnostics. Replace failed
Controller Failure			assembly as indicated.
1783 - Slot x Drive	None	ROM installation problem or	If this message appears
Array Controller		Array Accelerator board problem	immediately following a ROM
Failure			installation, the ROM is
			defective or not installed
			properly. Check that the
			controller is firmly inserted in its
			slot. Try upgrading the System
			ROMs. Otherwise, replace the
			Integrated Smart Array
			Controller.
1784 - Slot x Drive	None	Defective drive and/or cables	Check for loose cables. Replace
Array Drive Failure.			defective drive x and/or
The following SCSI			cable(s).
drive(s) should be
replaced: SCSI
port (y) SCSI ID (x).
			continued