Compaq ML370 This drive has been replaced, Was Replaced after another drive failed, Inadvertently

3-40Compaq ProLiant ML370 Maintenance and Service Guide

Table 3-16

ADU Diagnostic Messages continued

Message Description Recommended Action

Drive (bay) X is a replacement drive marked OK

This drive has been replaced and	Replace the drive.
marked OK by the firmware. This
may occur if a drive has an
intermittent failure (for example, if a
drive has previously failed, and then
when ADU is run, the drive starts
working again).

Drive (bay) X is	The indicated physical drive has	Replace the drive.
failed	failed.
Drive (bay) X is	This drive is being rebuilt from the	Normal operations should resume.
undergoing drive	corresponding mirror or parity data.
recovery
Drive (bay) X	The 210-megabyte hard drive has	Replace the drive.
needs replacing	firmware version 2.30 or 2.31.
Drive (bay) X	An error occurred while ADU was	If there were multiple errors, this drive may
upload code not	trying to read the upload code	need to be replaced.
readable	information from this drive.
Drive (bay) X	The physical drive was incorrectly	Replace the drive that was incorrectly replaced
was	replaced after another drive failed.	and replace the original drive that failed. Do not
inadvertently		run the System Configuration Utility and try to
replaced		reconfigure; data will be lost.
Drive Monitoring	ADU unable to get monitor and	Check for other errors (time-outs, and so on). If
features are	performance data due to fatal	no other errors occur, upgrade the firmware to a
unobtainable	command problem such as drive	version that supports monitor and performance,
	time-out, or unable to get data	if desired.
	because these features are not
	supported on the controller.
Drive Monitoring	The monitor and performance	Run the System Configuration Utility to initialize
is NOT enabled	features have not been enabled on	the monitor and performance features.
for SCSI Port x	this drive.
Drive ID x
Drive time-out	ADU issued a command to a physical	The drive or cable may be bad. Check the other
occurred on	drive and the command was never	error messages on the Diagnostics screen to
physical drive	acknowledged.	determine resolution.
bay X
Drive X indicates	Message indicates physical drive that	Examine the graphical drive representation on
position Y	appears to be scrambled or in a drive	ADU to determine proper drive locations.
	bay other than the one for which it	Remove drive X and place it in drive position Y.
	was originally configured.	Rearrange the drives according to the ADU
		instructions.
Duplicate write	Data could not be written to the Array	Replace the Array Accelerator board.
memory error	Accelerator board in duplicate due to
	the detection of parity errors. This is
	not a data loss situation.

continued