Compaq ML370 manual Right Side Panel, Removing the right side panel

Removal and Replacement Procedures 2-11

Right Side Panel

NOTE: This panel does not exist on the rack-mountable model. This procedure applies to the tower model only.

To remove the right side panel from the chassis:

1.Perform the preparation procedures. See “Powering Down the Server” earlier in this chapter.

2.Remove the front bezel (tower model only). See “Front Bezel” earlier in this chapter.

3.Remove the feet on the base of the right side panel. See “Feet” earlier in this chapter.

4.Remove the two Torx T-15 screws securing the right side panel to the front of the chassis .

5. Pull the right side panel back, then away from the chassis .
￿	2	￿	1

1

Figure 2-6. Removing the right side panel

Reverse steps 1 through 5 to replace the right side panel.