Compaq ML370 manual Pager test Select to test, Pager setup, Remotely and are using only one modem

Diagnostics and Troubleshooting 3-57

Table 3-19

Compaq System Configuration Utility Pager Settings for Booting into Compaq Utilities continued

Pager Data	Example	Description
	Setting
Pager test	Select to test	Use this to test the current pager settings. Press Enter to dial the pager
	pager setup	number, and the pager message (if present) displays. You must
		configure the computer before testing the pager and the Pager Status
		must be set to Enabled. Do not test the pager if you are running
		remotely and are using only one modem.
Serial interface	COM1	Select the communications port for the modem used by the pager and
		the remote ASR-2 functions. The options are COM1 and COM2.
Dial-in status	Enabled	Set Dial-In Status to Enabled. Be sure the Reset Boot option is set to
		Boot Compaq Utilities. When the system starts because of an ASR reset,
		it starts to the Compaq Utilities, sets the Management Modem to
		auto-answer, and waits for the administrator to dial in and run the
		Compaq Utilities.
		You automatically disable this option when you configure the software
		error recovery start option to Boot Operating System. When ASR pages
		you, you cannot dial in unless ASR-2 exceeds 10, the threshold number
		of server restart retries. When this happens, ASR-2 restarts the server
		into the Compaq Utilities and places the modem in auto-answer mode.
Dial-out status	Enabled	Allows ASR-2 to dial out to a remote workstation. If you selected this
		option, Dial-In Status is automatically selected.
		To use the dial-out feature, set Dial-Out Status to Enabled and set the
		Dial-Out String to the correct phone number. You must also set the
		Reset Boot option to Boot Compaq Utilities. When the system restarts
		because of an ASR reset, the administrator is paged via Pager Status
		and Pager Dial String, the system restarts to the Compaq Utilities, and
		dials out to the phone number provided in the Dial-Out string. The
		dial-out number will be tried five times. If it fails to connect after five
		attempts, the modem is put in auto-answer mode.
Dial-out string	555-1234	Enter the dial string followed by the remote computer telephone number.
Network status	Enabled	To allow network access to Compaq Utilities, set Network Status to
		Enabled and ensure the Reset Boot option is set to Boot Compaq
		Utilities.
Network		To use IPX network access, set Network Protocol to IPX. When the
protocol		system restarts to the Compaq Utilities because of an ASR reset, it loads
		IPX network support. This enables remote access using NVT.
		To use IP network access, set Network protocol to IP. Also make sure to
		set Network IP address, Network IP net mask, and Network IP router
		address. When the system restarts to the Compaq Utilities because of an
		ASR reset, it loads IP network support. This enables remote access
		using Telnet.
		NOTE: The Network Status must be set to Enabled for network access.

continued