Compaq ML370 Logical drive, Expansion process Expansion is in progress Slot x Drive, Primary Disk

3-16Compaq ProLiant ML370 Maintenance and Service Guide

Table 3-2

POST Error Messages continued

Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
1768 - Slot x Drive	None	SMART-2 Controller error	No action required. Appears
Array—Resuming			whenever a controller reset or
logical drive			power cycle occurs while array
expansion process.			expansion is in progress.
1769 - Slot x Drive	None	SMART-2 Controller error	Data has been lost while
Array—Drive(s)			expanding the array; therefore,
disabled due to			the drives have been
failure during			temporarily disabled. Press F2
expand. Select F1 to			to accept the data loss and
continue with logical			re-enable the logical drives.
drives disabled.			Restore data from backup.
Select F2 to accept
data loss and to
re-enable logical
drives.
1770 - Slot x drive	None	Firmware update need indicated	The indicated drives are running
array—critical drive			firmware that is known to cause
firmware problem			intermittent problems. Please
detected—please			use the Compaq Options
upgrade firmware on			ROMPaq utility to upgrade
the following drive(s)			firmware on all drives to the
using Options			latest revision. Press F1 or F2 to
ROMPaq (available			resume.
from
www.compaq.com):
SCSI port (y) SCSI
ID (x)
(RESUME = F1 or
F2 KEY)
1771 - Primary Disk	None	Internal and external hard drive	Run the System Configuration
Port Address		controllers are both assigned to	Utility and correct.
Assignment Conflict		the primary address.
1772 - Secondary	None	Address assignment conflict:	Run the System Configuration
Disk Port Address		internal and external hard drive	Utility and correct.
Assignment Conflict		controllers are both assigned to
		the secondary address.
1773 - Primary Fixed	None	Fixed disk drive error	Run the System Configuration
Disk Port Assignment			Utility and correct.
Conflict
			continued