Compaq ML370 Slot Mismatch Device Not updated Utility and correct Found, Processor, Log, Memory

Diagnostics and Troubleshooting 3-9

Table 3-2

POST Error Messages continued

	Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
175	- Configuration/	None	PCI board added, configuration	Run the System Configuration
Slot Mismatch Device			not updated	Utility and correct.
Found
177	- Configuration	None	Incomplete system configuration	Run the System Configuration
Not Complete				Utility and correct.
178	- Processor	None	Processor type or step does not	Run the System Configuration
Configuration Invalid			match configuration memory	Utility and correct.
180	- Log	None	N/A	N/A
Reinitialized
201	- Memory Error	None	RAM failure	Run Diagnostics. Replace failed
				assembly as indicated.
203	- Memory	None	RAM failure	Run Diagnostics. Replace failed
Address Error				assembly as indicated.
207	- Invalid Memory	None	Memory module installed	Verify placement of memory
Configuration—			incorrectly	modules.
Check DIMM [SIMM]
Installation

208 - Invalid Memory	1 long, 1 short	The speed of the memory is too
Speed—Check		slow, where: xx00 = expansion
DIMM [SIMM]		board SIMMs are too slow, or
Installation		00yy = system board SIMMs are
		too slow. xx and yy have
		corresponding bit set

The speed of the memory modules must be 60 ns. Verify the speed of the memory modules installed and replace.

209	- Memory	1 long, 1 short	Unable to size memory	Check DIMM installation, and if
Detection Failure.				error persists, call Compaq
Check Memory				service provider.
Installation
211	- Cache Switch	None	Switch not set properly during	Verify switch settings.
Set Incorrectly			installation or upgrade
212	- System	1 short	Processor in slot x failed	Run Diagnostics and replace
Processor Failed/				failed processor.
Mapped out
214	- DC-DC	None	PowerSafe Module (DC-DC	Run Diagnostics. Replace failed
Converter Failed			Converter) failed	assembly as indicated.
214	- Processor PPM	None	Indicated PPM (DC-DC Converter)	Replace failed assembly as
Failed Module X			failed	indicated.

continued