Compaq ML370 manual Nmi

Index 5

correctable error									overheat condition					3-48
threshold exceeded								3-48,	power AC overload					3-49
	3-49								power module
Diagnostic Error						3-60			failure	3-49
dirty data		3-36							not redundant				3-49
disable command issued								3-39	power supply
drive (bay)									failure	3-49
drive X failed						3-40			inserted		3-49
drive X inadvertently									not redundant				3-49
	replaced					3-40			removed		3-49
firmware needs									Processor Exception						3-61
	upgrading					3-39			Processor Prefailure					3-60
insufficient capacity								3-39	Required System Fan
invalid M&P stamp								3-39	Failure	3-61
loose cable					3-39				resolving	3-26
needs replacing							3-40		RIS copies between drives do not
replacement drive 3-39									match	3-43
replacement drive marked									SCSI Port X		3-43,3-44
	OK		3-40						Server Manager Failure							3-61
undergoing drive									set configuration command
	recovery					3-40			issued	3-44
upload code not									soft firmware upgrade
	readable					3-40			required		3-44
Drive (bay) X is non-Compaq									system configuration
supplied			3-41						battery low			3-49
drive monitoring									system crash		3-49
features unobtainable 3-40									system lockup			3-49
not enabled					3-40				unable to communicate with
drive time-out				3-40					drive 3-44
drive X indicates									uncorrectable error					3-48,3-49
position Y				3-40					unknown disable code						3-44
duplicate write memory									unrecoverable read error							3-44
error		3-40							UPS A/C Line Failure Shutdown
Error Detected On Boot									or Battery Low					3-61
Up	3-60								warning bit detected					3-45
error occurred reading RIS									warning, drive write cache
copy		3-41							enabled on X				3-44
fan									write memory error					3-45
failure			3-48						wrong Accelerator					3-45
inserted				3-48					error codes See also test error codes
not redundant						3-48			error codes, description					3-26
removed				3-48					ESD See electrostatic discharge
host bus error				3-49					event
identify controller data did not									AC voltage problem					3-49
match NVRAM							3-41		automatic OS shutdown							3-49
identify logical drive data did not									correctable error
match NVRAM							3-41		threshold exceeded							3-48,
insufficient adapter									3-49
resources				3-41					threshold passed						3-48
logical drive X					3-41,3-42				fan
loose cable detected							3-42,3-43		failure	3-48
mirror data miscompare								3-43	inserted		3-48
NMI	3-61								not redundant				3-48
no configuration for Accelerator									removed		3-48
board		3-43							host bus error		3-49
NVRAM configuration								3-43	overheat condition					3-48