Compaq ML370 manual Feet, Removing the feet from the chassis

2-8Compaq ProLiant ML370 Maintenance and Service Guide

Feet

NOTE: This procedure applies to the ProLiant ML370 tower model only.

To remove the feet from the chassis, one at a time:

1.Perform the preparation procedures. See “Powering Down the Server” earlier in this chapter.

2.Place the server on its right side (opposite from the large access panel).

3.Remove the T-15 screw from each foot ➊.

4.Pivot each foot down ➋; then pull it off the base of the chassis ➌.

3

2

1

Figure 2-3. Removing the feet from the chassis

Reverse steps 1 through 4 to replace the feet. Make sure each foot snaps securely into its holder.