Compaq ML370 manual Drive change Indicates that logical drive Array-Physical, Drive Position

3-14Compaq ProLiant ML370 Maintenance and Service Guide

Table 3-2

POST Error Messages continued

Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
*1724 - Slot x Drive	None	Drive change	Indicates that logical drive
Array—Physical			configuration has been updated
Drive Position			automatically following physical
Change(s) Detected –			drive position changes. Press F1
Logical drive			to resume.
configuration has
automatically been
updated
*1726 - Slot x Drive	None	Configuration update	Indicates Array Accelerator
Array—Array			configuration has been updated
Accelerator Memory			automatically due to
Size Change			replacement of Array
Detected			Accelerator (or controller) with
			one having different memory
			size. Press F1 to resume.
*1727 - Slot x Drive	None	Additional drives	This message indicates that the
Array—New Logical			controller has detected an
Drive(s) Attachment			additional array of drives that
Detected. If more			was attached when the power
than 32 logical			was off. The logical drive
drives, this message			configuration information has
will be followed by:			been updated to add the new
Auto-configuration			logical drives. The maximum
failed: Too many			number of logical drives
logical drives.			supported is 32. Additional
			logical drives will not be added
			to the configuration. Press F1 to
			resume.
1729 - Slot 1 Drive	None	Initial RAID configuration in	This message is normal
Array—Disk		progress.	following the initial
consistency			configuration of RAID 4 or
initialization in			RAID 5 logical drives. This POST
progress—RAID 4/5			message will go away and
performance may be			performance of the controller
lower until Auto			will improve after the parity data
Reliability Monitoring			has been initialized by ARM (an
has completed			automatic process than runs in
automatic parity			the background on the
consistency			controller).
initialization
1730 - Fixed Disk 0	None	Fixed disk drive error detected	Run the System Configuration
does not support			Utility and correct.
DMA Mode.
			continued