Compaq ML370 manual Memory, Sdram Dimm Slot Locations

Removal and Replacement Procedures 2-31

Memory

Compaq ProLiant ML370 Servers ship standard with a 128-MB Synchronous DRAM (SDRAM) dual inline memory module (DIMM) installed in DIMM slot 1. Memory is expandable to 4 GB (when 1-GB DIMMs are available).

1

2

3

4

Figure 2-27. DIMM slots on the system board

Table 2-3

SDRAM DIMM Slot Locations

Item Description

SDRAM DIMM slot 1 (populated with standard 128-MB DIMM)

SDRAM DIMM slot 2

SDRAM DIMM slot 3

￿SDRAM DIMM slot 4

CAUTION: Use only Compaq DIMMs. DIMMs from other sources may adversely affect data integrity. Power-On Self-Test (POST) will warn of nonsupported DIMMs.

IMPORTANT: The following guidelines MUST be followed when installing or replacing memory:

■Use 133-MHz, 64-, 128-, 256-, 512-MB or 1-GB registered SDRAM DIMMs, 3.3 volts, 72 bits wide, with Error Correction Code (ECC).

■Any combination of the above modules can be used.

■Install SDRAM DIMM modules one at a time in sequential order, starting with DIMM slot 1.

■Install DIMMs of the same speed. Do not install DIMM modules supporting different speeds.

■Install DIMMs only in one direction. Ensure that the notch on the module matches the tab on the DIMM slot and that the module is fully inserted and properly seated.