Compaq ML370 Hard parity error while reading Enable Array Accelerator, Press F1 to continue with

Diagnostics and Troubleshooting 3-25

Table 3-2

POST Error Messages continued

Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
1797 - Drive Array—	None	Hard parity error while reading	Enable Array Accelerator.
Array Accelerator		data from posted-writes memory
Read Error Occurred.
Data in Array
Accelerator has been
lost. Array
Accelerator is
disabled.
1798 - Drive Array—	None	Hard parity error while writing	Enable the Array Accelerator.
Array Accelerator		data to posted-writes memory
Write Error Occurred.
Array Accelerator is
disabled.
1799 - Drive Array—	None	Volume failed due to loss of data	Press F1 to continue with
Drive(s) Disabled due		in posted-writes memory.	logical drives disabled or F2 to
to Array Accelerator			accept data loss and re-enable
Data Loss. Select			logical drives.
“F1” to continue with
logical drives
disabled. Select “F2”
to accept data loss
and to re-enable
logical drives.
Beeps only: 2 Long	2L	No valid memory is present in	Replace failed memory with
		the system.	valid memory.
Beeps only:	2L, 2S	Power is cycled. Temperature too	Check fans.
2 Long + 2 Short		hot. Processor fan not installed
		or spinning.
(Run System	None	A configuration error occurred	Press F10 to run System
Configuration Utility -		during POST.	Configuration Utility.
F10 key)
(RESUME - F1 KEY)	None	As indicated to continue	Press F1.