Compaq ML370 manual Riser Board and Brace, Removing the riser board and brace

2-28Compaq ProLiant ML370 Maintenance and Service Guide

Riser Board and Brace

To remove the riser board and brace:

1.Perform the preparation procedures. See “Powering Down the Server” earlier in this chapter.

2.Open the front bezel (tower model only). See “Front Bezel” earlier in this chapter.

3.Remove any I/O expansion boards (if installed) from the riser board. See “I/O Expansion Board” earlier in this chapter.

4.Remove the large access panel. See “Large Access Panel” earlier in this chapter.

5.	Remove the two Torx T-15 screws securing the riser board and brace to the chassis .
6.	Slide the riser board and brace out of the server ￿.	￿

1

2

1

Figure 2-24. Removing the riser board and brace

Reverse steps 1 through 6 to replace the riser board and brace. Make sure that the board is seated securely before the screws are tightened.