Compaq ML370 manual Small Access Panel, Removing the small access panel

2-10Compaq ProLiant ML370 Maintenance and Service Guide

Small Access Panel

WARNING: To reduce the risk of personal injury from hot surfaces, allow internal system components to cool before touching them.

To remove the small access panel:

1.Perform the preparation procedures. See “Powering Down the Server” earlier in this chapter.

2.Open the front bezel (tower model only). See “Front Bezel” earlier in this chapter.

3.Loosen the thumbscrew securing the small access panel to the chassis ➊.

4.Slide the small access panel toward the rear of the unit about 1.5 cm (0.5 inches), then off to the side ➋.

2

1

Figure 2-5. Removing the small access panel

Reverse steps 1 through 4 to replace the small access panel.