Compaq ML370 manual Hard drive error, Failed Set Block Utility and correct Mode command

Diagnostics and Troubleshooting 3-15

Table 3-2

POST Error Messages continued

	Error Code	Audible Beeps	Probable Source of Problem	Recommended Action
1731	- Fixed Disk 1	None	Hard drive error	Run the System Configuration
does not support				Utility and correct.
DMA Mode.
1740	- Fixed Disk 0	None	Hard drive error	Run the System Configuration
failed Set Block				Utility and correct.
Mode command
1741	- Fixed Disk 1	None	Hard drive error	Run the System Configuration
failed Set Block				Utility and correct.
Mode command
1750	- Fixed Disk 0	None	Hard drive error	Run the System Configuration
failed Identify				Utility and correct.
command
1751	- Fixed Disk 1	None	Hard drive error	Run the System Configuration
failed Identify				Utility and correct.
command
1760	- Fixed Disk 0	None	Hard drive error	Run the System Configuration
does not support				Utility and correct.
Block Mode
1761	- Fixed Disk 1	None	Hard drive error	Run the System Configuration
does not support				Utility and correct.
Block Mode
1764	- Slot x Drive Array Capacity Expansion Process is temporarily disabled			Reattach or replace Array
(followed by one of the following):				Accelerator, wait until the Array
■ Expansion will resume when Array Accelerator has been reattached.				Accelerator batteries have
				charged, or for automatic data
■ Expansion will resume when Array Accelerator has been replaced.				recovery to complete, as
				indicated.

■Expansion will resume when Array Accelerator RAM allocation is successful.

■Expansion will resume when Array Accelerator battery reaches full charge.

■Expansion will resume when automatic data recovery has been completed.

*1766 - Slot x Drive Array requires System ROM Upgrade. Run Systems ROMPaq	Run the latest Systems ROMPaq
Utility.	Utility to upgrade the system
	ROMs. Press F1 to resume.
1767 - Slot x Drive Array Option ROM is Not Programmed Correctly or may Conflict	Remove or reconfigure
with the Memory Address Range of an Option Card. Check the Memory Address	conflicting Option cards,
Configuration of installed Option Card(s) or run Options ROMPaq Utility to attempt	especially any cards that are not
SMART-2/E Option ROM Reprogramming.	recognized by the System
	Configuration Utility. Try
	reprogramming the ROM on the
	SMART-2/E Controller using the
	latest Options ROMPaq
	(version 2.29 or higher).

continued