Preparation for USE, Unpacking And Set Up

PREPARATION FOR USE

Unpacking And Set Up

•Remove the unit from the carton, and remove all packing materials from the unit.

•Save the carton and packing materials in case the unit ever needs to be returned for service. Using the original carton and packing materials is the only way to safely repack the unit for shipment.

•Remove any descriptive labels or stickers from the top or front of the unit. Do not remove any labels from the back or bottom of the cabinet.

•Remove any small strips of tape that may have been used to prevent the CD door from opening in transit.

•Lift and open the CD door, and remove the dummy CD protection card from the CD compartment. Discard it and close the CD door.

•Unwind the FM wire antenna on the back cabinet and extend it to its full length.

•Unwind the AC power cord and extend it to its full length.

•Place the unit on a stable, level surface such as a table, desk, shelf, etc within easy reach of an AC outlet, out of direct sunlight, and away from sources of excessive heat, dust, moisture or humidity.

Protect Your Furniture

This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture.

CKD1137_053105.p65

1/6/2005, 14:22