Cowon Systems iAUDIO U5 manual Connecting to PC and Transferring Files

Page 19

Introducing iAUDIO U5

19

8. Connecting to PC and Transferring Files

1.

Connect the player to a PC

2. When connected, the screen will show

3. The iAUDIO drive will appear as

using the supplied USB cable.

the following screen.

shown and can be accessed like a

4.

Launch Windows File Explorer or JetAudio.

disk drive using Windows Explorer

 

5.You can copy any files including MP 3files to and from “iAUDIO” Drive

6.To disconnect the player from the PC, first make sure that file transfers are complete and then, single-click on icon on the windows tray.

7.Click on the following pop-up message when

it appears

8.When “Safely Remove Hardware” message appears, and the TFT LCD displays a battery you may disconnect the USB cable.

-The iAUDIO U5 can recognize up to 500 folders and 2000 files.- If iAUDIO drive does not appear in either My Computer or Windows Explorer, check the connection and settings, and then re-connect (Separate driver installation is required for Windows 98).

-If the USB cable is connected after running ‘Safely Remove Hardware’ wizard from the steps listed above, the player stays in the battery charging mode. To access its memory, iAUDIO must be disconnected first and reconnected.

-If the device is connected through a USB HUB, the device won’t be charged. The device must be connected directly to a USB port installed on a PC.

-The ‘safely remove hardware’ icon may not appear in windows 98/98SE. In such case, close JetAudio, then remove USB cable to disconnect.

-If the following message appears, run Safely Remove Hardware after a few minutes.

iAUDIO U5

Page 18 Page 20
Image 19
Page 18 Page 20
Contents User Guide Copyright Notice On-line registration and support Legal NoticeTable of Contents Table of Contents Safety Tips IAUDIO U5 at a Glance Introducing iAUDIO U5Timer function World’s most powerful sound effectsEasily upgradeable firmware Convenient features for learning languagePackage contents Features and specification Introducing iAUDIO U5 Identifying the Parts TFT LCD Display Charging iAUDIO U5 Using an AC adapter sold separatelyUsing a PC connection Installing the driver Windows 98 Driver SetupIntroducing iAUDIO U5 Continue to click Next Connecting to PC and Transferring Files Basic Controls Using iAUDIO U5Pull power switch upwards during playback to turn off Quick Start GuideMoves to Default Mode Cancel Moves to the leftSelects mode Chooses an item Plays music Cancels changesPlaying Audio Files Using Advanced FeaturesPlaying Audio Using Advanced Features Setting and Using Preset Channels Using FM RadioListening to FM Radio Recording FM Radio FM Radio tuning mode, pressingScheduled Recording of FM Radio TimerRecording with Built-in Microphone Recording Using Built-In MicrophoneDuring recording, press Settings Menu List Using Advanced SettingsJetEffect Menu ScreenEqualizer Play Mode Display Using Advanced SettingsAuto off TimerThis function does not operate during playback General FM Radio RecordingSystem Information Resetting the Player to Factory Default Settings Firmware UpgradeAdditional Information Country Selection Player is on but there is no sound Am still confused even after reading the manualCannot turn on the player Buttons won’t workCharacters on the display are corrupted Computer cannot recognize the player when connectedIAUDIO does not play properly when memory is full There is too much noise in my recordings
Top Page Image Contents