TIME FORMAT
* Press UP ( ) button to toggle between 12 and 24 hour time format
DAY OF THE WEEK LANGUAGE * Press and hold DOWN ( ) button for 3 seconds: the default language abbreviation will flash (example – EN)
* Continue holding DOWN ( ) button until the desired day of the week language abbreviation is selected.
* Release the DOWN ( ) button to confirm the setting.
M 
D
PM
1
2
M | D |
| 1 |
| 2 |
M | D |
PM
1
2
M 
D
PM
SETTING THE ALARM | |
To set the Alarm1, | |
* Press MODE button once to display | |
ALARM TIME 1. If the alarm is off, | |
the default time “6:00” will be | |
displayed. | |
* Press and hold SET1 button for two | |
seconds. The hour digit will flash. | |
* Enter the hour using DOWN ( ) or | |
UP ( ). |
|
* Press SET1 button again. | |
The minute digits will flash. | |
* Enter the minutes using DOWN ( ) | |
or UP ( | ). |
* Press SET1 button again to | |
confirm: | 1 ] will appear on the |
an icon [ | |
display next to the alarm time.
* Repeat the same procedure to set an Alarm2, using SET2 button.
M 
D
PM
AM
M 
D
PM
AM
M 
D
PM
AM1
1
2
M 
D
LIGHT/SNOOZE
When the alarm sounds, press the LIGHT/SNOOZE button to temporarily stop the alarm. After the LIGHT/
PM
1
2
ALARMS
There are two available alarms
5
SNOOZE is depressed, the alarm sound will resume in five minutes.
If the alarm is not disabled after that, it will sound for four more minutes and then will stop by itself.
DISABLING ALARM
Press SET1 or SET2 buttons on the unit to disable any of the alarms.
When Alarm1 and Alarm2 are disabled, an applicable icon [ 1 ] or [ 2 ]will disappear from the unit’s display.
6
PROGRAMMING THE SNOOZE INTERVAL | |||
* Press and hold SET1 button for two seconds to | |||
activate an Alarm1 programming mode. Alarm1 hour | |||
digit will flash. | ) or DOWN ( ) | ||
* Adjust the desired hour using UP ( | |||
buttons. |
|
|
|
* Press SET1 button: the minute digits will flash. | |||
* Adjust the desired minutes using UP ( | ) or |
| |
DOWN ( | ) buttons. |
|
|
* Press SET1 button again: | M | D | |
the snooze interval minutes |
|
| |
will flash. |
| PM |
|
|
|
| 1 |
|
|
| 2 |
* Adjust the desired interval time using UP ( | ) or | ||
DOWN ( | )buttons. |
|
|
* Press SET1 button to confirm set snooze interval. Use the same procedure to program the snooze interval for Alarm2.
INDOOR TEMPERATURE
The indoor temperature shares the same display’s line with the calendar and the day of the week.
NOTE: If the indoor temperature goes above or below operating range stated in specifications, the display will show dashes [ 
].
MOON PHASE
Moon phase indicator is displayed in accordance with the calendar.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
New | Waning | First | Waxing Full Waning | Last | Waning | ||||||||||||
Moon | Crescent | Quarter | Gibbous Moon Gibbous | Quarter | Crescent | ||||||||||||
PRECAUTIONS
This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions: * Do not immerse the unit in water.
* Do not clean the unit with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.
* Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.
* Do not tamper with the unit’s internal components. Doing so will invalidate the warranty and may cause damage. The unit contains no
* Use only fresh batteries. Do not mix new and old batteries. * Read the user's manual thoroughly before operating
the unit.
7
8