Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or

service center.

WARNING: Do not open the set as there is a risk of electric shock. Under no circum- stances should you try to repair the set yourself, as this will invalidate the warranty.

No sound.

–Volume not adjusted.

• Adjust the VOLUME.

CD playback does not work.

–CD badly scratched or dirty.

• Replace/ clean CD.

–Laser lens steamed up.

•Wait until lens has adjusted to room temperature

– Laser lens dirty.

•Clean lens by playing a CD lens cleaning disc.

–CD-R is non-finalized.

• Use a finalized CD-R.

Occasional crackling sound during FM broadcast.

– Weak signal.

• Extend the pigtail antenna fully.

Continuous crackling/ hiss disturbance during MW broadcast.

–Electrical interference from TVs, computers, fluorescent lamps, etc.

• Move set away from other electrical equipment

The alarm does not function.

– Alarm time not set.

•See section on Setting alarm time.

CAUTION

Visible and invisible laser radiation. If the cover is open, do not look at the beam.

High voltage! Do not open.You run the risk of getting an electric shock.The machine does not contain any user-serviceable parts.

Modification of the product could result in hazardous radiation of EMC or other unsafe operation.