Emerson DTE810 owner manual Installation

Page 6

INSTALLATION

Unravel the AC cord and connect it to a conveniently

 

 

 

located AC outlet having 120V and 60Hz only. The

 

 

 

 

 

 

Clock Display will illuminate and a flashing time will

 

 

AC Outlet

appear in the window. The Clock Display will continue

 

 

 

 

 

to flash until the time has been set.

 

 

 

CAUTION: To prevent electric shock, match wide blade

AC Plug

of plug to wide slot, fully insert.

 

 

 

If the AC cord is disconnected or if there is a power

failure, this electronic clock is designed to continue operating internally (without

showing the time on the Clock Display) with a 9 volt

 

 

 

 

 

 

 

 

battery (not included). To install the battery, open the

 

 

 

 

 

 

 

 

battery compartment by pressing in the tab and lifting off

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the door. Connect the battery to the terminals of the

 

 

 

 

 

 

 

 

battery snap inside the compartment (use of an alkaline

 

 

 

 

 

 

 

 

 

 

 

 

9V

 

battery is recommended) and slide the battery

 

 

 

 

 

 

 

 

 

 

 

 

 

compartment cover into place.

 

 

 

 

 

 

 

 

Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again 2 or

3 minutes later. The preset times should continue operating. If a flashing time appears on the Clock Display,

it indicates the battery is dead or not connected properly. The 9 volt battery will keep the internal time accurately for approximately 30 minutes. If the power is restored after 30 minutes, the time may need to be reset.

Replacement of batteries must be done by an Adult.

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

Do not use rechargeable batteries.

The supply terminals are not to be short-circuited.

Non-rechargeable batteries are not to be recharged.

Exhausted batteries are to be removed.

Only batteries of the equivalent type are to be used.

Batteries are to be inserted with the correct polarity.

Choking Hazard - - Small Parts and Packing Materials Not for children under 8 years.

*All materials for fastening or packing purchases are not part of the unit and should be discarded for children’s safety.

*Please keep all information for future reference.

*This is not a toy.

5

Image 6
Contents DTE810 Safetyprecautions Safety Precautions Page Location of Controls Installation Remove the TRY ME Battery BOX Indicated inside the battery compartmentTo SET or Reset the Actual Time OperationTo Play the Radio To SET or Reset the Alarm Time To SET the Alarm to Wake to RadioTo SET the Alarm to Wake to Dora To Shut Alarm OFF Snooze FunctionTo Activate the Sleep Function To Activate the Night Light Troubleshooting Guide RadioEmerson Radio Corp Limited Warranty Emerson