Emerson CKS2237 owner manual Changing the Lithium Battery, Dimmer Control

Page 11

2.To increase or decrease the amount of time that the radio will play before shutting off, hold the SLEEP button and press either the SET + or SET – button to change the display to the desired sleep time, up to a maximum of 90 minutes or a minimum of 2 minutes.

Note: When you change the sleep timer from the 10 minute default setting to a different setting, the new setting becomes the default setting. Whenever you activate the sleep timer it will begin with your new default setting and count down to zero from that point.

3.To cancel the sleep timer before it counts down to “00” and shut the radio ‘Off’ immediately, press the SNOOZE bar.

IMPORTANT:

Remember that the station and volume settings you choose for the Sleep To Music operation are the same settings you will hear if you set the alarm for wake to radio the following morning.

DIMMER CONTROL

The DIMMER switch was set to the ‘HIGH’ position at our factory. If you find the clock display is too bright in a darkened room, set the DIMMER switch to the ‘LOW’ position.

CHANGING THE LITHIUM BATTERY

Like all batteries, eventually the built in lithium battery will need to be replaced. A number of factors, such as, the length of time between the date the radio was manufactured and the date you plugged it in for the first time determine the amount of time before replacement. During this initial storage period, the lithium battery is supplying power to the SmartSet® computer memory. Once you plug the radio in, your household outlet supplies the power, and the battery is not being used. A fresh lithium battery can supply power to the SmartSet® computer for at least 3 years even if it is never connected to an AC power supply. If your radio was connected to your AC supply within a few months after it was manufactured, and you experience only the normal, nuisance type, short duration power interruptions, your battery may last for up to 5 years or even longer.

When the battery power drops below a certain level, the “BATT. LOW” indicator will come on. When you see this indicator, you should change the battery as soon as it is convenient for you to do so. To change the battery proceed as follows:

1.Purchase a replacement 3V lithium battery wherever batteries are sold. The battery type is CR2430 or equivalent.

10

Image 11
Contents With SmartSet Congratulations FCC Information Important NotesPreparation for USE Unpacking and SET UPPower Source Top Panel Right Side Location of Controls and IndicatorsDate Display Setting the TIME, the First TimeOperating Instructions Year Display Daylight Saving and Leap Year AdjustmentsManual Time Adjustments Adjusting the Wake UP TimesChecking the Wake UP Times and Alarm Mode Selecting the Alarm ModeWake to Radio Listening to the RadioAntenna Information Radio and Buzzer Operation Snooze AlarmSleep to Music Timer Wake to BuzzerDimmer Control Changing the Lithium BatteryBe Careful not to Lose this Small Screw Resetting the Clock After a Total Memory LossImportant Note Care and Maintenance Emerson Radio Corp Limited Warranty Emerson