2.Remove the battery from its package so it is ready to install.
3.Important: Leave the radio power cord connected to your AC outlet. This will provide power to the SmartSet® computer memory while the original lithium battery is removed.
4.Place the radio face down and use a small screw driver to remove the screw securing the battery holder to the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW !
5.Slide the battery holder out of the cabinet. Then remove the original battery from the holder and insert the new battery into the holder the same way, with the positive(+) side facing up.
6.Slide the holder with the new battery back into the opening in the cabinet.
7.Replace the screw that secures the battery holder in the cabinet.
8.Place the radio standing up and confirm that the “BATT. LOW” indicator is ‘Off’.
9.Save these instructions. You’ll have to do this again five to eight years from now!
POSITIVE(+) SIDE |
RESETTING THE CLOCK AFTER A TOTAL MEMORY LOSS
If you do not change the built in lithium battery within a reasonable period of time after you see the low battery warning indicator, the lithium battery may become exhausted and will no longer be able to supply back up power to the SmartSet® internal computer. If the unit is disconnected from the AC outlet after the battery is exhausted, or if a power interruption occurs, the SmartSet® memory will be lost and the clock will need to be reset when the power is restored. Be sure to install a fresh lithium battery before you reset the clock, otherwise the clock will need to be reset each time the power is interrupted.
11