Playing Compact Discs

NOTE: This CD player can read CD-R/RW discs, in addition to normal CDs, however; the compatibility of CD-R/RW discs may be affected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using. 100% compatibility cannot be guaranteed. This is not an indication of a problem with the player.

Normal Playback

1.) Press the POWER/ALARM OFF button to switch the unit ‘On’. The POWER indicator will light.

2.) Press FUNCTION button repeatedly until the "cd" appears in the display.

3.) Press on the CD door in the area marked OPEN to open the door.The display will

shows "OP" (open) for 5 seconds, then change to show clock. If you have not already done so, remove the ‘dummy CD’ transit

protection card from the CD player and discard it.

4.) Place your disc on the center spindle with the printed label side facing up. Press down near the center of the disc to make sure it is firmly ‘seated’ on the spindle, press on the CD door in the area marked OPEN to close the

CD door.

5.) The “ – –” of “cd: – –” flashes while the player reads the disc. The display will show the total

number of	tracks for a few seconds and then
return to the correct time.
6.) Press the		button to begin playback. The

display will briefly show “cd: 01” (Track 1) and playback on track 1 begins. After a few seconds the display returns to the correct time.

To see the track number at any time during playback press the DISPLAY button. The track

number will appear for several seconds and then the display returns to the correct time.

PLAY

NOTE: If the disc is inserted incorrectly, or if the disc is badly scratched and cannot be read by the player, “d ISC” will appear on the display for a few seconds, and then the display returns to the correct time.