Storing and Using Preset Stations

You can store up to a total of 5 FM radio stations in the memory.

1Tune to your desired station (see TUNING TO RADIO STATIONS).

2To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double beep.

™Display shows the preset number of your station. 3 Repeat steps 1 and 2 to store your other stations.

•You can overwrite a preset station by storing another frequency in its place.

4 Press a PRESET button 1-5 to listen to a preset station.

USING THE ALARM

GENERAL

Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend:

•ALARM - radio mode

•ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.

SETTING THE ALARM TIME AND MODE (See 3)

1.Check the radio is switched off.

2.Press ALARM or ALARM to on.

™ Display: OFF disappears under the respective AL or AL icon.

3.Press and hold SET AL or SET AL until alarm time digits flash.

4.Hold down or press HR + or MIN + repeatedly to set and adjust the hours and minutes respectively. Release HR + or MIN + when you have reached the correct setting.

5.After both the hours and minutes are set, press SET AL or SET AL to confirm the setting.

Helpful hints:

–If you have selected ALARM , make sure you have properly tuned to a station before turning off the set.

–If you set and activate the same time for both alarms, only the ALARM will be activate at the set time.