iHome manual Setting Up the iH5, Setting Clock Time and Calendar, Clock Adj Button to confirm

Page 12

Setting Up the iH5

Your iH5 Home System comes from the factory preset to Eastern Standard Time. Just follow these simple steps

to match the setting to where you live.

 

1. Depending on your location and whether or not DST (Daylight Savings Time) is in effect, set the

DST

Switch located on the back of the unit to +1 or -1 to activate the DST adjustment feature. Activating the +1

switch will advance the time one hour.

 

2. Press and hold the Time Zone Button located on the back of the unit for approx. 2 seconds until the

Time Zone Indicator at the lower right hand side of the display shows current time zone. Turn the

Setting

Knob to select the time zone.

 

ATL - Atlantic

EAS - Eastern

CEN - Central

MTN - Mountain

PAC - Pacific

ALS - Alaska

HAI - Hawaii

3.Press the Time Zone Button again to exit the setting mode. You should hear 2 beeps indicating the time zone has been set.

4.If for any reason the time showing is not correct, please see Setting Clock Time and Calendar to set the clock.

Setting Clock Time and Calendar

1.Press and hold the Clock Adj Button located on the back of the unit for 2 seconds until the display flashes. Turn the Setting Knob until the current time is displayed. Remember to set the correct AM or PM (an icon to the right of the time display is the PM indicator; there is no AM indicator).

2.Press the Clock Adj Button again to confirm clock setting. You should hear 1 beep indicating the clock time is set.

3. The year display at the lower right will flash. Press the

Clock Adj Button to accept the current setting,

or turn the

Setting Knob until current year is displayed. Press the

Clock Adj Button to confirm year

setting. You should hear 1 beep indicating the year is set.

 

 

 

4. The date display at the lower right will flash. Press the

Clock Adj Button to accept the current setting,

or turn the the

Setting Knob until current date is displayed. Press the

Clock Adj Button to confirm

date setting. You should hear 2 beeps indicating the date is set and will exit Clock and Calendar setting mode. 11

Image 12
Contents Home System For Your iPod Page Table of Contents Consumer Guide to Product Safety Consumer Guide to Product Safety FCC Information Install AM loop antenna Install AC AdaptorGetting Started IPod InsertsInstall/Replace Backup Battery Controls and Indicators Using The Optional Remote Control Unit By phone toll freeClock Display Setting Up the iH5 Setting Clock Time and CalendarClock Adj Button to confirm Setting Alarm Time Charging your iPodListening to your iPod Play/PauseVolume Knob on the iH5 or Volume+ Alarm Operation Alarm Reset/Power Off Button or Power On/Off Button onWake-To Button Sleep Operation Snooze/Dimmer OperationLine Out Operation Troubleshooting Symptom Possible Problem SolutionIPod or iPod Shuffle, try reducing the output volume on Solucionando problemas Síntoma Causa SoluciónEl iPod no carga El iPod no está instalado correctamente Limited 90-Day Warranty Information