GE MG27006 manual Getting Started, Setup and Connections

Page 4

Getting Started

Setup and Connections

Step 1:

Unpack the TV and remote control.

Step 2:

Connect your TV. Connect the cable from your cable system or off-air antenna to the cable in-jack on the back of the TV, as shown.

Step 3:

Plug in the TV. Plug the end of the power cord into the wall outlet, matching the wide blade of the plug with the wide slot in the outlet. Be sure to insert the plug completely.

Step 4:

Put batteries in the remote.

1.Remove the battery compartment cover from the back of the remote.

2.Insert batteries as shown, matching the + and – ends of each battery in the compartment.

3.Replace the cover.

Step 5:

Turn on the TV.

Press the TV button on the remote.

Read the next section, The Menu System, which is a brief overview of the basic rules for getting around in the menus using the remote or the TV's front control panel.

Step 6:

Auto Channel Search.

Perform an Auto Channel Search (described in the Channel menu section).

Caution: If you choose to use a stand with your TV, take precautions that the stand or other furniture the TV is placed on is properly located and of adequate size and strength to prevent the TV from accidentally being pushed off, pulled off, or tipped over. This could cause damage to the TV and/or personal injury.

ANTENNA, CABLE, CABLE BOX OR VCR

TV

CABLE/

ANTENNA

4

Image 4
Contents TV User’s Guide Important Information Table of Contents Setup and Connections Getting StartedMenu System Point and Select MethodTV Main Menu Picture Quality MenuScreen Menu Channel MenuChip and Parental Controls Unlocking V-Chip Parental ControlsChannel Marker Time MenuFront Panel Using the Remote Tour of the RemoteTesting the Remote Programming the RemoteUsing the Remote to Control a Device Programming the Remote to Control an RCA Audio DeviceVCR Troubleshooting TV will not turn on or controls don’t workCare and Cleaning Care and CleaningIndex 60%