GE MG27006 manual Using the Remote to Control a Device

Using the Remote

Programming the Remote to Control an RCA Audio Device:

Your remote controls only RCA audio equipment such as an audio receiver or amplifier—it does not control other brands of audio equipment. Also, the remote may need to be programmed for your equipment. This remote may not operate all of the components listed at the end of this section. Use the codes at the end of this section or on the sheet packed in with your remote.

1.Turn on the component to be programmed.

2.Look up your brand and its code number(s) on the code list.

3.Press and hold the AUDIO button.

4.Enter the code from the code list.

5.Release the AUDIO button and press POWER or CHAN (channel up) or CHAN (channel down) to see if the audio device responds to the remote commands.

Using the Remote to Control a Device

Once the remote has been programmed successfully, you are ready to use it to control your devices.

To operate the device:

1.Press the device button (TV, VCR1, VCR2•LD, or SAT•CABLE) to set the remote to control the device.

2.Press POWER to turn the device on or off.

3.Use the remote buttons that apply to that device.

11