Connecting to External AV Sources

The unit supports an AV signal input function. Use the audio/ video cable to connect the unit to an external audio/

video signal source such as a DVD player, VCR, etc. Be sure to observe the color code when connecting audio/video cables. (Cables not included.)

Note: Noise may occur in speakers when there is an external audio signal input while playing a DVD. Unplug the audio cord to clear the noise.

Connecting Headphones

Plug headphones into the headphones jack. The speakers turn off automatically when headphones are connected. (Headphones not included.)

Note: Excessively loud volume can damage your hearing. Turn down the volume before you connect headphone, and then raise the volume to comfortable level.

Using Remote Control

Remove the remote control from the storage slot located on the back panel behind the viewing stand. Point the remote control unit at the remote sensor within a range of 5 meters and angles of 60 degrees, and without obstacles between remote control and remote sensor.

Notes:

∙ Improper use of the battery may cause overheating, explosion or ignition, which can result in an injury or a fire. Battery leakage may damage the remote control.

∙ Do not expose the remote control unit to direct sunlight.

∙ Do not recharge, disassemble, deform or heat the battery.

∙ Do not put the battery in fire or water. ∙ Immediately replace the exhausted

battery.

∙ Remove battery when the remote is not in use for a long time.

To order a replacement remote control, go to www.AccessHD.tv

Rev: 09/2009

AccessHD® 7” LCD Panel Television