RCA RIR205 user manual Front view, Back view, To install the Enabler, To turn on the Wi-Fi Enabler

Page 13

Before you begin

Frequently asked questions

For answers to frequently asked questions (FAQ's), go to www.rcainfiniteradio.com.

General controls of RCA Wi-Fi Enabler (for RIR205)

Front view

Antenna

WPS MODE WPS WIRELESS POWER

PRESS

WiFi ENABLER

WAN

LAN

Back view

 

 

WAN port – connect to your

 

existing access point,

 

 

broadband modem or

 

Power

Ethernet router/hub/switch

adapter jack

 

 

RESET

WAN

LAN

POWER

• LAN port – if your modem or

 

Reset push

router/hub/switch has only

 

button

one LAN port and is

 

 

connected to your PC,

 

 

disconnect the Ethernet cable from the modem/router/hub/ switch and connect it to the Enabler's LAN port.

•You can also connect it to your computer's Ethernet port to access the Enabler's web- administration page for troubleshooting purposes. Refer to page 31 for more information.

To install the Enabler:

The Enabler can be installed vertically or horizontally. Remove the standing brackets for horizontal installation. Rotate the antenna to improve signal reception.

 

 

WiFi ENABLER

WPS

WPS

PRESS

 

PRESS

WiFi ENABLER

 

To turn on the Wi-Fi Enabler:

The Enabler will turn on automatically when power is connected.

To check the RCA Wi-Fi Enabler's status by reading the LEDs (Lights):

•Normally the POWER, WAN and WIRELESS LEDs will be on when the enabler is operating as a router.

•The LAN LED will be on if there is an Ethernet cable connected from the LAN port on the Enabler to a computer.

•The MODE LED will be off when the Enabler is operating as a Router.

•The MODE LED will be on when the Enabler is operating as an (AP) Access Point.

To rescan the network configuration:

•Your Wi-Fi Enabler comes preconfigured from the factory so normally no rescan should be necessary.

•Press and hold the WPS key for 3 seconds. The MODE LED then starts blinking. This will indicate to the user that the unit is scanning the network to determine the correct mode for the new environment (i.e. either router or AP).

•If during a scanning, the unit cannot determine the mode or needs more information (i.e. no response from the WAN connection, PPPOE, fixed IP address connection, etc) the unit will start flashing the MODE, WPS and WIRELESS LEDs.

To reset the Enabler:

•If you are unable to connect the radio to the Wi-Fi enabler, press and hold the RESET for 10 seconds to reset the Wi-Fi enable back to factory defaults. After resetting the Wi-Fi enabler, try

connecting again.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents RIR200 RIR205 Contents Technical specification Safety informationElectrical power source FCC informationPrecautions for the player Important battery precautionsProduct registration For your records Important Safety Instructions End user license agreement End user license agreementWindows Media Unpack the unit Before you beginDear RCA customer For RIR205 onlyOptional Insert AAA batteries in the base of the radio Setup your RCA Infinite Radio accountsPlug in and turn on the radio Optional Connect the radio using an Ethernet cableWired Set up the radioWireless Wireless network name SsidDemonstration mode After connecting to the InternetAbout password Getting the latest firmware and informationTo turn on the Wi-Fi Enabler To install the EnablerTo rescan the network configuration To reset the EnablerTo choose Wi-Fi Enabler placement Placement of Wi-Fi EnablerTo reduce interference Front and top General controlsRear Clock and alarm Volume controlUsing the menus Turning on or offAccessing the digital clock Clock and alarmSetting the clock Using the alarm clockTo activate or deactivate the alarm clock Sleep modeTo turn off the alarm clock when it sounds Slacker Radio Accessing Slacker RadioListening to Slacker Radio To select a station free account usersTag Options Internet Radio Accessing Internet RadioListening to Internet Radio To select a stationAdding Internet Radio stations Recording Internet RadioTo add Internet Radio stations FM/AM Tuner Accessing FM/AM RadioFM/AM antenna Listening to FM/AM RadioInternal Memory Accessing Internal MemoryListening to recordings Deleting recordingsUSB Input Accessing USB Input modeListening to music files Deleting filesWeather broadcast WeatherEmergency Broadcast System alert Settings More information Troubleshooting tipsFurther help on Wi-Fi Enabler for RIR205 Server Error To access the web-based utility of the Wi-Fi Enabler Web-based utility of Wi-Fi EnablerConnection Info Specifications Check for updates Technical specificationCopyright warning Limited warranty Warranty informationMonth Limited Warranty Applies to RCA Audio/Video Products How to make a warranty claimFor Canada Customers, please ship to Audiovox Return Centre What we will doV2.0
Top Page Image Contents