EP30200 OPERATION
NOTE:
The EP30 does not have a power switch.
11.Position the terminal lug of the bonding cable against the cleaned surface of the rail. Position the gun against the cable lug so that the brazing pin is at the top edge of the cable lug hole. See Figure 4 below.
Figure 4. Gun position
IMPORTANT
Make sure the correct ferrule and brazing pin are used. The pin braze must be made in the top of the hole when brazing to a vertical surface.
12.Hold the gun firmly with both hands and pull the trigger once. The electronics will finish the braze automatically.
13.Hold the gun in place for 3-4 seconds after the brazing is complete to allow for cooling. Then remove the gun straight backwards without pulling trigger.
14.After the braze has cooled, knock the shank off the braz- ing pin using a hammer.
15.Use a new ceramic ring for each new pin braze.
NOTE:
A red light indicates low batteries on the unit. Charge as soon as possible.
EP30200 User Manual ◄ 9