Additional Safety Rules

1.Don't use the tool in the presence of flammable liquids or gases.

2.Check the blade carefully for cracks or damage before operation. Replace cracked or damaged blade immediately.

3.Use only flanges specified for this tool.

4.Be careful not t o damage the arbor, flanges (especially the installing sur- face) or bolt. Damage t o these parts could result in blade breakage.

5.Make sure that the turn base is properly secured so it will not move during operation.

6.Always keep the table top clear of chips, small pieces and so on in order t o maintain a safe, clean surface.

7.Avoid cutting nails. Inspect for and remove all nails from the workpiece be- fore operation.

8.Make sure the shaft lock is released before the switch is turned on.

9.Be sure that the blade does not contact the turn base in the lowest position. IO. Hold the handle firmly.

11. Keep hands away from rotating parts.

12.Make sure the blade is not contacting the workpiece before the switch is turned on.

13.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade.

14.Wait until the blade attains full speed before cutting.

15.Stop operation immediately if you notice anything abnormal.

16.Do not attempt t o lock the trigger in the on position.

17.Always switch off and wait for the blade t o come t o a complete stop before removing, securing workpiece, changing workpiece position, angle or the blade itself.

18.Don't abuse cord. Never yank cord to disconnect it from the receptacle. Keep cord away from heat, oil, water and sharp edges.

WARNING

For Your Own Safety Read Instruction

Manual Before Operating Miter Saw

1.Wear eye protection.

2.Keep hands out of path of saw blade.

3.Do not operate saw without guards in place.

4.Do not perform any operation freehand.

5.Never reach around saw blade.

6.Shut off power and wait for saw blade t o stop before servicing or adjusting tool.

SAVE THESE INSTRUCTIONS.