Emptying dust bag

When the dust bag is about half full, re- move the dust bag from the tool and pull the fastener out. Empty the dust bag of i t s contents, tapping it lightly so as to remove particles adhering to the insides which might hamper collection.

Fig. 14

Securing workpiece

By turning the knob on the vise counterclockwise, the screw is released and the vise shaft can be moved rapidly in and out. By turning the knob clockwise, the screw remains secured. To grip workpieces, turn the knob gently clockwise, until the projection reaches i t s topmost position, then fasten securely. If the knob is forced in or pulled out while being turned clockwise, the projection may stop a t an angle. In this case, turn the knob back counterclockwise until the screw is released, before turning again gently clock~se .

CAUTION :

.Grip workpieces only when the projec- tion i s a t the topmost position. Other- wise the workpiece cannot be properly gripped and might pop out or damage the blade.

(Dangerous way to grip workpiece)

Fig. 17

0 When making miter cuts of 35 degrees or more, to the side that the vise is mounted, the safety cover movement may be slightly obstructed by the vise. This only occurs when the workpiece dimensions are more than 90 mm (3-1/2”) in width and less than 60 mm (2-3/8“) in height, or less than 90 mm (3-1/2”) in width and less than 30 mm (1-3/16”) in height. If this situation occurs, re-mount the vise on the other side of the tool’s base.