HOSE TYPES
The rated working pressure of the hydraulic hose must be equal to or higher than the relief valve setting on the hy- draulic system. There are three types of hydraulic hose that meet this requirement and are authorized for use with Stanley Hydraulic Tools. They are:
Certified
HOSE SAFETY TAGS
To help ensure your safety, the following DANGER tags are attached to all hose purchased from Stanley Hydraulic Tools. DO NOT REMOVE THESE TAGS.
If the information on a tag is illegible because of wear or damage, replace the tag immediately. A new tag may be obtained from your Stanley Distributor.
THE TAG SHOWN BELOW IS ATTACHED TO “CERTIFIED
|
|
|
|
|
|
|
|
|
|
|
| A G |
| D A N G E R |
|
|
|
|
|
| D A N G E R |
| T |
|
|
|
|
|
|
|
|
|
| I S |
| 1. FAILURE TO USE HYDRAULIC HOSE LABELED AND CERTIFIED AS |
|
|
|
|
| 3. | DO NOT EXCEED HOSE WORKING PRESSURE OR ABUSE HOSE. IMPROPER USE |
| H |
| WHEN USING HYDRAULIC TOOLS ON OR NEAR ELECTRIC LINES MAY RESULT IN |
|
|
|
|
|
| OR HANDLING OF HOSE COULD RESULT IN BURST OR OTHER HOSE FAILURE. |
| T |
| DEATH OR SERIOUS INJURY. |
|
|
|
|
|
| KEEP HOSE AS FAR AWAY AS POSSIBLE FROM BODY AND DO NOT PERMIT DIRECT |
| VE |
| FOR PROPER AND SAFE OPERATION MAKE SURE THAT YOU HAVE BEEN PROP- |
|
|
|
|
|
| CONTACT DURING USE. CONTACT AT THE BURST CAN CAUSE BODILY INJECTION |
|
|
|
|
|
|
|
| AND SEVERE PERSONAL INJURY. | ||
| O |
| ERLY TRAINED IN CORRECT PROCEDURES REQUIRED FOR WORK ON OR AROUND |
|
|
|
|
|
|
|
|
| ELECTRIC LINES. |
|
|
|
|
| 4. | HANDLE AND ROUTE HOSE CAREFULLY TO AVOID KINKING, ABRASION, CUTTING, OR | |
| M |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| CONTACT WITH HIGH TEMPERATURE SURFACES. DO NOT USE IF KINKED. DO NOT | |
| E |
|
|
|
|
|
|
|
| |
|
| 2. BEFORE USING HYDRAULIC HOSE LABELED AND CERTIFIED AS |
|
|
|
|
|
| USE HOSE TO PULL OR LIFT TOOLS, POWER UNITS, ETC. | |
| R |
|
|
|
|
|
|
| ||
|
| ON OR NEAR ELECTRIC LINES. WIPE THE ENTIRE LENGTH OF THE HOSE AND FIT- |
|
|
|
|
| 5. CHECK ENTIRE HOSE FOR CUTS CRACKS LEAKS ABRASIONS, BULGES, OR DAM- | ||
| T |
|
|
|
|
|
| |||
|
| TING WITH A CLEAN DRY ABSORBENT CLOTH TO REMOVE DIRT AND MOISTURE AND |
|
|
|
|
| |||
|
|
|
|
|
|
|
| AGE TO COUPLINGS IF ANY OF THESE CONDITIONS EXIST, REPLACE THE HOSE | ||
| N O |
| TEST HOSE FOR MAXIMUM ALLOWABLE CURRENT LEAKAGE IN ACCORDANCE WITH |
|
|
|
|
|
| |
|
|
|
|
|
|
|
| IMMEDIATELY. NEVER USE TAPE OR ANY DEVICE TO ATTEMPT TO MEND THE HOSE. | ||
|
| SAFETY DEPARTMENT INSTRUCTIONS. |
|
|
|
|
| 6. | ||
| D O |
|
|
|
|
|
|
| AFTER EACH USE STORE IN A CLEAN DRY AREA. | |
|
| SEE OTHER SIDE |
|
|
|
|
|
| SEE OTHER SIDE | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SIDE 2 |
|
|
| SIDE 1 |
|
|
|
|
|
|
(Shown smaller than actual size)
THE TAG SHOWN BELOW IS ATTACHED TO “CONDUCTIVE” HOSE.
D O N O T R E M O V E T H I S T A G
D O N O T R E M O V E T H I S T A G
| D A N G E R |
|
| D A N G E R |
|
|
|
|
|
1. | DO NOT USE THIS HYDRAULIC HOSE ON OR NEAR ELECTRIC LINES. THIS HOSE IS | 5. | CHECK ENTIRE HOSE FOR CUTS CRACKS LEAKS ABRASIONS, BULGES, OR DAMAGE TO | |
| NOT LABELED OR CERTIFIED AS |
| COUPLINGS IF ANY OF THESE CONDITIONS EXIST, REPLACE THE HOSE IMMEDIATELY. | |
| ELECTRICAL LINES MAY RESULT IN DEATH OR SERIOUS INJURY. |
| NEVER USE TAPE OR ANY DEVICE TO ATTEMPT TO MEND THE HOSE. | |
2. | FOR PROPER AND SAFE OPERATION MAKE SURE THAT YOU HAVE BEEN PROPERLY | 6. | AFTER EACH USE STORE IN A CLEAN DRY AREA. | |
| TRAINED IN CORRECT PROCEDURES REQUIRED FOR WORK ON OR AROUND ELEC- |
|
| |
| TRIC LINES. |
|
|
3.DO NOT EXCEED HOSE WORKING PRESSURE OR ABUSE HOSE. IMPROPER USE OR HANDLING OF HOSE COULD RESULT IN BURST OR OTHER HOSE FAILURE. KEEP HOSE AS FAR AWAY AS POSSIBLE FROM BODY AND DO NOT PERMIT DIRECT CONTACT DURING USE. CONTACT AT THE BURST CAN CAUSE BODILY INJECTION AND SEVERE PERSONAL INJURY.
4.HANDLE AND ROUTE HOSE CAREFULLY TO AVOID KINKING, CUTTING, OR CONTACT WITH HIGH TEMPERATURE SURFACES. DO NOT USE IF KINKED. DO NOT USE HOSE TO PULL OR LIFT TOOLS, POWER UNITS, ETC.
|
| SEE OTHER SIDE |
|
|
|
|
| SEE OTHER SIDE |
|
|
|
| SIDE 1 |
|
|
|
|
| SIDE 2 | ||
|
|
| (Shown smaller than actual size) |
D O N O T R E M O V E T H I S T A G
8 ► RS25 User Manual