step 2 | Connections |
Turn off all equipment before connection and read the appropriate operating instructions.
Do not connect the AC power supply cord until all other connections are complete.
Getting Started
1
6 | 5 | 2 | 1 | 4 | 3 |
|
| R | L | R | L |
SUBWOOFER | CENTER |
| FRONT | SURROUND | |
3 
2
Main unit
YAUX
|
| L |
| PB |
|
|
| R |
AV OUT | PR | FM ANT |
| (75 ) | |
OPTICAL | COMPONENT | VIDEO OUT |
IN | VIDEO OUT |
|
Start Guide
1Speaker connections
Setup example
Pay attention to the type of speaker and the connector color when you place the speakers.
Connect to the terminals of the same color.
Use of the speaker cable stickers is convenient when making cable connections.
Quick
PURPLE | GREEN | RED | WHITE | GRAY |
SUBWOOFER | CENTER | FRONT | FRONT | SURROUND |
|
| (R) | (L) | (R) |
e.g. Surround speaker (L)
Speaker cable sticker (included)
SURROUND
Lch
3
Insert the wire fully, taking care not to insert beyond the wire insulation.
: White
: Blue
Main unit
6 | 5 | 2 | 1 | 4 | 3 |
|
| R | L | R | L |
SUBWOOFER | CENTER | FRONT | SURROUND | ||
BLUE
SURROUND
(L)
Push!
●Be careful not to cross (short circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
DO
NOT
RQTX0217
2Radio antenna connections
Using an indoor antenna |
|
| Using an outdoor antenna |
Adhesive tape | FM indoor antenna |
| Use outdoor antenna if FM radio reception is poor. |
(included) |
| ≥Disconnect the antenna when the unit is not in use. | |
|
| ||
| Affix this end of the antenna |
| ≥Do not use the outdoor antenna during an electrical storm. |
Main unit |
| Main unit | |
where reception is best. |
|
FM ANT |
| FM ANT | ||
(75 | ) | FM outdoor antenna | (75 | ) |
| 75 coaxial cable |
| ||
|
| [Using a TV antenna |
| |
|
| (not included) |
| |
|
| (not included)] |
| |
|
|
|
| |
|
| The antenna should be |
|
|
|
| installed by a competent |
|
|
|
| technician. | Antenna plug (not included) |
|
|
|
|
| |
§Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.
1 Remove a piece of the outer | 2 Carefully pull the tabs apart | 3 Install the coaxial cable. | 4 Attach the cover. | ||
vinyl insulator. |
| to remove the cover. | Clamp the cable conductor, and |
| |
|
|
|
| wind it around so that it does not |
|
10 mm (13/32z) |
| | contact anything else. |
| |
10 mm (13/32z) | Peel back | | |
|
|
|
|
|
|
| |
| 7 mm (9/32z) |
|
| Clamp with pliers |
|
6