TROUBLESHOOTING | ||
|
|
|
| Observe all Safety Guidelines detailed throughout this manual |
|
|
|
|
PROBLEMS
(SYMPTOMS)
POSSIBLE
CAUSE
RECOMMENDED
COURSE OF ACTION
Digital Display Models Error Codes
| Fault Code | Description |
| Possible Adjustments |
Err 81 | Motor overload, long term. | 1. The wire drive motor has over- | 1. | Check that the electrode slides |
|
| heated. |
| easily through the gun and cable. |
|
|
| 2. | Remove tight bends from the gun |
|
|
|
| and cable. |
|
|
| 3. | Check that the spindle brake is |
|
|
|
| not too tight. |
|
|
| 4. | Verify a high quality electrode is |
|
|
|
| being used. |
|
|
| 5. | Wait for the error to reset and the |
|
|
|
| motor to cool (approximately 1 |
|
|
|
| minute). |
|
|
|
|
|
Err 82 | Motor overload, short term. | 1. The wire drive motor current draw | 1. | Check that motor can turn freely |
|
| has exceeded limits, usually |
| when idle arm is open. |
|
| because the motor is in a locked | 2. | Verify that the gears are free of |
|
| rotor state. |
| debris and dirt. |
|
|
|
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Authorized Field Service Facility for technical troubleshooting assistance before you proceed.