Lincoln Electric IM553-C manual Battery Charging, To prevent Explosion when, Muffler

Page 11

A-4

A-4

 

 

Battery Charging

The Classic II is equipped with a wet charged battery. The charging current is automatically regulated when the battery is low (after starting the engine) to a trickle current when the battery is fully charged.

When replacing, jumping or otherwise connecting the battery to the battery cables, the proper polarity must be observed. This system is NEGATIVE GROUND.

WARNING

GASES FROM BATTERY can explode.

• Keep sparks, flame and cigarettes away.

BATTERY ACID can burn eyes and skin.

Wear gloves and eye protection and be careful when boosting, charging or working near battery.

To prevent EXPLOSION when:

a)Installing a new battery - disconnect the negative cable from the old battery first and connect the negative cable to the new battery last.

b)Connecting a battery charger - remove the battery from the welder by disconnecting the negative cable first, then the positive cable and battery clamp. When reinstalling, connect the negative cable last.

c)Using a booster - connect the positive lead to the battery first, then connect the negative lead to the ground lead on the base.

To prevent ELECTRICAL DAMAGE when:

a)Installing a new battery.

b)Using a booster.

Use correct polarity - Negative Ground.

To prevent BATTERY DISCHARGE, if you have an ignition switch, turn it off when engine is not running.

• To prevent BATTERY BUCKLING, tighten nuts on

battery clamp until snug.

------------------------------------------------------------------------

Muffler

This welder is supplied with an adjustable rain cap for the muffler. Install the rain cap using the clamp pro- vided with the outlet facing away from the direction in which this unit will be transported. This will minimize the amount of water and debris which could enter the muffler during transportation.

CLASSIC II DEUTZ

Image 11
Contents Classic California Proposition 65 Warnings SafetyElectric Shock can kill Cylinder may explode if damaged Sûreté Pour Soudage a L’Arc Précautions DE SûretéOn-Line Product Registration Please Examine Carton and Equipment For Damage ImmediatelyTable of Contents Technical Specifications Classic II Deutz K1406 InstallationFalling Equipment can cause Location/VentilationGrounding Lift BailOil PRE-OPERATION ServiceUndercarriages Polarity Control and Cable SizesMuffler Battery ChargingTo prevent Explosion when To prevent Electrical Damage whenDuty Cycle Safety PrecautionsOperation Cold Weather StartingIdler Operation Auxiliary PowerCooling System Bearings MaintenanceGeneral Instructions Commutator and Brushes Idler MaintenanceHOW to USE Troubleshooting Guide 1TROUBLESHOOTINGE-1Problems TroubleshootingTroubleshooting Good Electronic Idler Troubleshooting GuideClassic II Deutz DiagramsL9920 L9919 Classic II Wiring Diagram Dimension Print Classic II Deutz Precaucion Warnung