MAGNUM 250 LX - OPERATING INSTRUCTIONS
4.Select wire of size and type needed. Wire must be straight, with no kinks or bends. Check drive roller for the correct groove positioning for the size wire selected. See "Drive Roll Groove Selection", for details.
5.Put wire spool on shaft. After spool wire is in place, make sure the Spool Brake Lever is riding on outer flange of wire spool and, the Roller Arm is underneath of spool riding on wire.
CORRECT
SPOOL BRAKE
LEVER
ROLLER ARM
INCORRECT
ROLLER ARM
SPOOL BRAKE
LEVER
6.Unspool and straighten about 6 inches of wire, then route into plastic tube.
WIRE SPOOL 
PLASTIC
TUBE
7.Push wire until end of wire exits back tube and enters front tube, passing between drive roll & pressure idler roll.
PRESSURE | DRIVE ROLL | BACK TUBE |
|
| |
LEVER |
|
|
FRONT |
| PRESSURE |
LID | IDLER | |
TUBE | ROLL |
8.Push wire until wire end extends approximately 6" (150 mm) past end of gas diffuser.
9.Screw spool cover knob onto spool gun cover (making sure all keyways line up).
SPOOL COVER
KNOB
SPOOL COVER
10.Obtain contact tip size to match wire selected. Slip contact tip over wire and screw into diffuser. Tighten securely.
CONTACT TIP
DIFFUSER
GAS NOZZLE
11.Cut off wire close to contact tip, then screw gas nozzle over the diffuser
6