MAGNUM 250 LX - INSTALLATION
Unpacking the Spool Gun
Safety Precautions
–Read "Safety Precautions" in the Operating Manual before proceeding. Only personnel that have read and understood the Operating Manual should install and operate this equipment.
–Power source must be turned "OFF" and power leads disconnected when installing this unit.
Unpacking the Spool Gun
Carefully unpack your Magnum 250 LX Spool Gun and attach the Barrel Assembly, and make sure you have all of the parts shown below.
BARREL ASSEMBLY
CABLE ASSEMBLY 25’
|
| MAGNUM 250 LX - SPOOL GUN | ||
| Contact Tip 3/64th (1.2mm) | Included | ||
| Contact Tip .035 (0.9mm) | Installed on Barrel Assembly | ||
OPERATOR’S | KP52FN | Gas Diffuser | Installed on Barrel Assembly | |
MANUAL | Gas Nozzle | Installed on Barrel Assembly | ||
Drive Roll (.030 to .035 / 3/64th) | Installed | |||
| ||||
|
|
|
| |
3