Lincoln Electric IM839 manual DeviceNet Module DIP Switches Bank S1

A-2 INSTALLATION A-2

Install the DeviceNet bulkhead connector by removing the plastic plug covering the circular hole (ITEM 4) in the front lower panel assembly. Install the 5-pin con- nector and mounting plate over the mounting studs as shown in (Figure A.1). Fasten with two of the supplied locknuts.

If a Wire Drive Interface Module is not installed (Figure A.1), locate the 6-pin to 4-pin interconnect. Insert the interconnect between J73 on the DeviceNet module and J16 in the machine harness. Discard the 4-pin to 4-pin interconnect and proceed to the next section.

If a Wire Drive Interface Module is installed (Figure A.2), locate the 4-pin to 4-pin interconnect. Insert the interconnect between J73 on the DeviceNet module and J81 on the Wire Drive Interface Module. Discard the 6-pin to 4-pin interconnect.

ONLY FOR MACHINES WITH A DEVICENET MODULE AND A WIRE DRIVE INTERFACE MODULE

4-pin to 4-pin interconnect

Wire Drive Module

FIGURE A.2

DeviceNet Baud rate: The default Baud rate is 125K. If another Baud rate is desired, see table 2 in this sec- tion and set switches 1 and 2 of bank S2. Every device on a DeviceNet network must have the same Baud Rate.

DeviceNet Module DIP Switches:

Bank S1

switch 1 = Object Instance LSB (Default = OFF) (See Table 1)

switch 2 = Object Instance MSB (Default = OFF) (See Table 1)

Object Instance (Table 1)

Switch 2	Switch 1	Instance
Off	Off	0
Off	On	1
On	Off	2
On	On	3

switch 3 = Equipment Group 1 Select (Default = Off) switch 4 = Equipment Group 2 Select (Default = Off) switch 5 = Reserved for future use

switch 6 = Reserved for future use switch 7 = Reserved for future use switch 8 = Reserved for future use

Bank S2

switch 1 = DeviceNet Baud Rate (Default = OFF) (See Table 2)

switch 2 = DeviceNet Baud Rate (Default = OFF) (See Table 2)

DeviceNet Baud Rate (Table 2)

Switch 1	Switch 2	Baud Rate
Off	Off	125K
On	Off	250K
On	On	500K
On	On	Programmable Value

switch 3 = DeviceNet Mac ID (Default = Off) (See Table 3)

switch 4 = DeviceNet Mac ID (Default = On) (See Table 3)

switch 5 = DeviceNet Mac ID (Default = On) (See Table 3)

switch 6 = DeviceNet Mac ID (Default = On) (See Table 3)

switch 7 = DeviceNet Mac ID (Default = On) (See Table 3)

switch 8 = DeviceNet Mac ID (Default = On) (See Table 3)

DeviceNet MAC ID:

The default Mac ID is 62. Every device on the DeviceNet network should have a unique ID. If anoth- er MAC ID is desired, refer to Table 3.

•Complete Board Installation

Close door assembly insuring not to cut or pinch any wires.

Reinstall the screws in door assembly.

Re-apply power and verify the appropriate status lights on the Power Wave are green. Discard any remaining hardware.

DEVICENET MODULE