Operation
I | . I |
Turn the tool on and wait until the blade attains full speed. Then rest the base flat on the workpiece and gently move the tool forward along the previously marked cut- ting line. When cutting curves, advance the tool very slowly.
CAUTION :
Failure to hold the tool base flush with the workpiece may cause blade breakage.
Bevel cutting
With the base tilted, you can make bevel cuts a t any angle between 0" and 45" (left or right).
Loosen the bolt on the back of the base with the hex wrench and slide the base backwards. Tilt the base to the desired angle. The edge of the housing indicates the bevel angle.
Then check the contact between the back edge of the blade and the roller.
Now tighten the bolt securely on the back of the base.
Edge of housing
9