OPERATION
MAINTENANCE
ACCESSORIES
To turn on the work light, slide the switch to ON.
To turn off the work light, slide the switch to OFF.
Fig. 3
ON
OFF 
Switch
The
Fig. 4
Tool holder
WARNING
To reduce the risk of injury, always unplug the charger and remove the battery pack from the charger or work light before performing any maintenance. Never disassemble the work light, bat- tery pack or charger. Contact a MILWAUKEE service facility for ALL repairs.
WARNING
Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog or go
Front tangs
Belt clip
Stud
Pin
Clamp release
Clamp
Maintain Work Light
Keep your work light, battery pack and charger in good repair by adopting a regular maintenance program.
If the work light does not work prop- erly, return the work light to a MILWAUKEE service facility for repairs.
a catalog, contact your local distributor or a service center listed on the back cover of this operator’s manual.
Tool release lever
Attaching the Belt Clip
The belt clip can be mounted to tool belts, bags, buckets, etc. To mount the belt clip:
1.Pull up the clamp release. The clamp will pop out.
2.Slide the clamp over the tool belt, bag, bucket, etc.
3.Press in the clamp to tighten.
Using the Clip-Lok Tool Holder
1.To attach the tool to the belt clip, slide the tool holder over the stud on the belt clip until it is held in place by the protrud- ing pin.
2.To release the tool from the belt clip, grasp the tool handle, push down on the tool release lever with your thumb, and pull up on the tool.
45