Assembly
Tools needed for assembly (not provided):
Electric drill
center punch and hammer 10.5mm drill bit
M12 x P1.75 tap
12mm and 19mm wrenches 4mm hex wrench
Hardware needed for assembly (not provided):
4 M12 flat washers
4 M12 x P1.75 hex cap screws (length will depend upon thickness of saw table)
Exposed metal areas of the Stock Feeder have been factory coated with a protectant. This should be removed with a soft cloth dampened with kerosene or mineral spirits. Do not use gasoline, acetone or lacquer thinner for this purpose. Do not get solvents near plastic or rubber parts, and do not use an abrasive pad because it may scratch metal surfaces.
The Stock Feeder should be mounted securely to a table saw in a
The stock feeder and the table saw to which you are mounting it should both be disconnected from power during installation.
1.Determine the mounting location for the stand. Keep in mind the overall length of the horizontal arm, so that after it is mounted to the stand it will have enough adjustment for positioning the Stock Feeder.
2.Use the provided boring template to find the centerline spacing for the holes in the base of the stand. Clean the table surface, then remove the backing from the boring template and carefully stick the boring template into place on the mounting surface. (NOTE: This template is also on page 27.)
3.Center punch and drill four 10.5 mm diameter holes in the surface, then tap the holes with M12 x P1.75 threads.
4.Peel off the boring template and discard.
5.Place the stand in position, align the four holes in the stand with the holes in the table, and insert four M12 hex cap screws with four M12 flat washers (not provided). See
Figure 1. | Figure 1 |
| |
| 9 |