Tilting the Table
1.Disconnect the machine from the power source, unplug.
2.Loosen the lock knobs (A, Fig. 13).
3.Tilt table up to 45 degrees to the right, or up to 10 degrees to the left.
4.Tighten the lock knobs.
Note: Table stop bolt (B, Fig. 13) must be removed to tilt table to the left.
Height Scale Adjustment
1.Disconnect the machine from the power source, unplug.
2.The upper blade guide should be set about 1/8” above the material to be cut.
3.Measure from the table top to the bottom of the blade guides, Figure 14.
4.Set the indicator to this measurement on the height scale. Grasp the end of the indicator (C, Fig. 15) between your finger, and thumb. Move the indicator into position.
15
Figure 13
Figure 14
Figure 15