Unpacking
Remove the packing material from the band saw. Note: Remove the plywood and bolts from the base. Inspect the machine for damage. Report any damage to your distributor and shipping agent.
Move the saw to its permanent working location. The site should be dry, well lit, and have enough room to handle long stock and the service and/or adjustment of the machine from any side.
Move the band saw off the skid. Clean all rust protected surfaces with a mild solvent or diesel fuel and a soft cloth. Do not use lacquer thinner, paint thinner, or gasoline. These will damage painted surfaces.
Contents of Shipping Container
1 - Band Saw
1 - Table
1 - Owner’s Manual
1 - Warranty Card
1 - Accessory Package Contains:
2 - Extension Straps
1 - Extension Base Accessory Packeg Include 2 - Knobs
1 - 5mm Hex Wrench
1 - 4mm Hex Wrench
1 - Handle
1 - 10/12mm Wrench
1 - 12/14mm Wrench
1 - Trunnion Support Bracket
4- Hex Cap Bolts
4- Lock Washers 5/16”
8 -
Tools Included for Assembly
1 - 10/12mm Open End Wrench
1 - 12/14mm Open End Wrench
1 - 5mm Hex Wrench
Tools Required for Assembly & Adjustments
1 - Combination Square
1 - Cross Point Screw Driver
8