OPERATION
Bracing for forward rotation
Bracing for reverse rotation
WARNING
To reduce the risk of injury, wear safety goggles or glasses with side shields. Unplug the tool before changing accessories or making adjustments.
WARNING
To reduce the risk of personal injury whendrilling,alwaysholdtoolbythe insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wir- ing or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator.
Bit binding (Fig. 3)
Fig. 3
B
A
If the bit binds, the drill will suddenly react in the opposite direction of the rotation of the bit. Figure 3 shows the path of reaction
(B)if the drill bit binds while being driven in forward (A). The operator should reduce the chances of a sudden reaction by following the instructions listed below.
The operator should also prepare for a
Fig. 4
B
C
A
Fig. 5
D
B
A
Fig. 6
C
B
A
Fig. 7
D
B
A
WARNING
When drilling with a single speed drill or in HI with a two speed drill, always hold the drill securely us- ing the pipe handle, or brace the drill against a solid fixed object in preparation for a sudden reaction. When drilling in LO with a two speed drill, always brace the drill against a solid fixed object in preparation for a sudden reaction.
When drilling, never use your body to brace drill.
Never put your hands (or other body parts) between the part of the drill being braced and the object it is be- ing braced against. Hands (or other body parts) that are in the path of the reaction can be pinched, crushed and broken.
sudden reaction by holding securely using the pipe handle or bracing against a solid fixed object.
To reduce the chance of bit binding
•Use sharp bits. Sharp bits are less likely to bind when drilling.
•Use the proper bit for the job. There are many types of bits designed for specific purposes.
•Use the proper speed for the size bit. Larger bits should be run at the lower speed. Driving larger bits at high speeds will increase the chance of the bit binding and increase the chance of reaction.
•Avoid drilling warped, wet, knotty, and or pitchy material if possible.
•Avoid drilling in material that you suspect contains hidden nails or other things that may cause the bit to bind.
The direction of reaction is always opposite of the direction of bit rotation.
Reaction is even more likely to occur when enlarging already existing holes and at the point when the bit breaks through the other side of the material.
When drilling in forward, the bit will rotate in a clockwise direction. If the bit binds in the hole, the bit will come to a sudden stop and drill will suddenly react in a counterclockwise direction.
Figures 4 and 5 show examples of a Hole Hawg® properly braced for forward rota- tion.
A.Forward (clockwise) rotation
B.Reaction
C.Brace drill with pipe handle here
D.Brace drill with motor housing here
If the bit binds, the pipe handle or the motor housing braced against the stud will hold the drill in position.
When drilling in reverse, the bit will rotate in a counterclockwise direction. If the bit binds in the hole, the bit will come to a sudden stop and the drill will suddenly react in a clockwise direction.
Figures 6 and 7 show examples of the Hole Hawg® properly braced for reverse rotation.
A.Reverse (counterclockwise) rotation
B.Reaction
C.Brace drill with pipe handle here
D.Brace drill with motor housing here
If the bit binds, the pipe handle or the motor housing braced against the stud will hold the drill in position.
8 | 9 |