Installation Instructions
Install the Case in the Window
Step 1. Open the window and mark the centerline of the window stool (or desired air conditioner location).
Step 2. Carefully place the case on the window stool and align the center mark on the bottom front with the centerline of the stool
Screw(Type A)
Frame guide
Cabinet
OUTDOOR
ABOUT 1/2"
Step 3. Pull the window down behind the top
| mounting rail | Window Sash | Top |
|
| Sash | mountaing rail |
|
| seal |
|
Top |
| Cabinet |
|
mounting |
| Frame curtains | |
rail |
| Window stool |
|
|
|
| |
| Front angle |
|
|
NOTE: Do not shut the window so tightly that movement of the frame curtains is restricted.
Step 4. Loosely assemble the sill supports.
INDOOR | OUTDOOR |
Sill Support
Nut
Bolt
INDOOR
Step 6. Adjust the bolt and the nut in each support so that the case is installed with a slight downward tilt (about 1/2").
Step 7. Secure the case to the window stool by using 3 type B screws.
Sash
Track
Front Angle
Screw(Type B)
Sill Support
Step 8. Pull the frame curtains to each window sash track. Attach them on each side to the window sash and the window stool using 4 type C screws.
Step 5. Select the position that will place the sill supports near the outermost point on the sill. Attach the sill supports to the case track hole in relation to the selected position using 2 type A screws in each support.
Screw
(Type C)
Install the Window Locking Bracket and the Foam Top Window Gasket
Step 1. Attach the window locking bracket with type C screw.
Step 2. Cut the foam top window gasket to the window width.
Step 3. Stuff the foam between the glass and the window to prevent air and insects from getting into the room.
Screw
(Type C)
Foam top window gasket
13