OPERATION
WARNING Always remove battery pack before changing or removing acces- sories. Only use accessories specifically recommended for this tool. Others may be hazardous.
WARNING To reduce the risk of injury, wear safety goggles or glasses with side shields.
Fuel Gauge
To determine the amount of charge left in the bat- tery, pull the trigger. The Fuel Gauge will light up for
To signal the end of charge, 1 light on the fuel gauge will Àash for
Installing Bits
Always remove the battery before inserting or removing bits. Select the proper style and size bit for the job.
This tool is equipped with a spindle lock. The chuck can be tightened with one hand, creating higher grip strengths on the bit.
1.To open the chuck jaws, turn the sleeve in the counterclockwise direction.
When using drill bits, allow the bit to strike the bottom of the chuck. Center the bit in the chuck jaws and lift it about PP 1/16” off of
the bottom.
When using screwdriver bits, insert the bit far enough for the chuck jaws to grip the hex of the bit.
2.To close the chuck jaws, turn the sleeve in the clockwise direction. The bit is secure when the chuck makes a ratcheting sound and the sleeve can not be rotated any further.
3.To remove the bit, turn the sleeve in the coun- terclockwise direction.
NOTE: A ratcheting sound may be heard when the chuck is opened or closed. This noise is part of the locking feature, and does not indicate a problem with the chuck’s operation.
Selecting Hammer, Drill or Drive Action
1.To use the hammerdrilling mode, rotate the application
selector collar until the hammer
symbol 
appears in line with 
the arrow. Apply pressure to the 
bit to engage the hammering 
mechanism.
NOTE: The number selected on the torque selector collar has no effect on operation of the drill in hammer mode.
NOTE: When using carbide bits, do not use wa- ter to settle dust. Do not attempt to drill through steel reinforcing rods. This will damage the carbide bits.
2.To use the drilling only mode,
rotate the application selector 
collar until the drill symbol 
appears in line with the arrow. 
NOTE: The number selected on 
the torque selector collar has no 
effect on operation of the drill in 
drilling mode.
3.To use the driving screws mode rotate the application
selector collar until the drive symbol 
appears in line with the arrow. Then rotate the torque selector collar until the desired clutch setting appears in line with the arrow.
The adjustable clutch, when properly adjusted, will slip at a preset torque to prevent driving the screw too deep into different materials and to prevent damage to the screw or tool.