Wilton 4002 manual Replacement parts, Upper cover can either be hinged back or removed

Page 15

Typical operations (continued)

Inside curves can be sanded on the upper sanding belt idler wheel (see

Figure 30). The upper cover can either be hinged back or removed.

Figure 30. Sanding inside curves

Replacement parts

This section provides exploded view illustrations that show the replacement parts for the 1-Inch Belt / 8-Inch Disc Sander. Also provided are parts listings that provide part number and description. The item numbers shown on the illustrations relate to the item number in the facing parts listing.

15

Order replacement parts from:

Wilton Corporation

300 South Hicks Road Palatine, IL 60067 708/934-6000

FAX: 708\934-7813 or 1-800-626-9676

Identify the replacement part by the part number shown in the parts listing. Be sure to include the model number and serial number of your machine when ordering replacement parts to assure that you will receive the correct part.

Image 15

Contents Model Operating Instructions Parts ManualTable of Contents Specifications General SpecificationsWhen servicing machine Machinery general safety warningsWhen setting up machine When using machineGeneral electrical cautions Wire sizesUnpacking Setting up the sanderCleaning AssemblySetup Fastening sander to supporting surfaceDust chutes Grounding instructions Connecting sander to power sourceTracking the sanding belt Locking switch in the OFF positionOperating instructions Starting and stopping sanderBelt table adjustments Setting the belt -degree stopSetting the belt table at a 45-degree angle Changing abrasive belts Disc table adjustmentsAdjusting the table angle Adjusting the disc-to-table gapRemoving the belt Changing abrasive discsTypical operations Miter gaugeMotor Belt Sanding outside curves Upper cover can either be hinged back or removed Replacement partsExploded View of Sander Belt Sander Parts Part Number Description Exploded View of Sander Disc Sander Parts E m Wilton Corporation