Wilton 4002 manual Sanding outside curves

Page 14

14

Typical operations (continued)

Sanding aluminum on the disc unit with the table tilted and using the miter gauge as a guide (see Figure 26).

NOTE: Always sand on the left (downward) side of the sanding disc, as shown. Sanding on the right (upward) side of the sanding disc could cause the workpiece to fly up which could be hazardous.

Sanding outside curves on the belt unit with the platen removed (see Figure 27).

Polishing using the accessory felt belt in place of the sanding belt (see Figure 28).

NOTE: Most polishing operations are performed with the platen removed.

Sanding in tight areas with the sanding belt (see Figure 29).

Figure 27. Sanding outside curves

Figure 29. Sanding in tight areas

Figure 26. Sanding aluminum

Figure 28. Polishing using a felt belt

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Operating Instructions Parts Manual ModelTable of Contents General Specifications SpecificationsWhen using machine Machinery general safety warningsWhen setting up machine When servicing machineWire sizes General electrical cautionsAssembly Setting up the sanderCleaning UnpackingDust chutes SetupFastening sander to supporting surface Connecting sander to power source Grounding instructionsStarting and stopping sander Locking switch in the OFF positionOperating instructions Tracking the sanding beltSetting the belt table at a 45-degree angle Belt table adjustmentsSetting the belt -degree stop Adjusting the disc-to-table gap Disc table adjustmentsAdjusting the table angle Changing abrasive beltsChanging abrasive discs Removing the beltMotor Belt Typical operationsMiter gauge Sanding outside curves Replacement parts Upper cover can either be hinged back or removedExploded View of Sander Belt Sander Parts Part Number Description Exploded View of Sander Disc Sander Parts E m Wilton Corporation
Top Page Image Contents