Wagner SprayTech 3000, 3500 Setting Up to Stripe or Spray, Connect the hose and gun

Page 11

Setting Up to Stripe or Spray

1.Connect the hose and gun.

a.If the hose is not already installed on the striper, remove the plastic cap plug from the outlet tee

at the spray pump, and screw a conductive or grounded 3000 psi airless spray hose onto fluid outlet.

b.Connect an airless spray gun to the other end of the hose.

c.Do not use steel braided airless hose. Use nylon braided airless hose only.

NOTE: Do not use thread sealer on swivel

unions as they are made to self-seal.

Use thread seal on tapered male threads only.

2.Remove the snap-on cover plate over the piston.

3. Grounding

WARNING

To reduce the risk of static sparking, fire or explosion which can result in serious bodily injury and property damage, always ground the sprayer and system components and the object being sprayed, as instructed in the safety warning section of this manual.

A small steel chain grounding strap is installed at the factory to prevent static build-up.

4. Flush the sprayer

As per "Flushing Procedure" in this manual.

3.Fill the packing nut/wet cup with 5 drops of Airlessco Throat Seal Oil (TSO) and then reinstall snap-on piston cover plate

Failure to lubricate the piston properly with throat seal oil can cause premature wear and damage to piston and packings.

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents SERVICE/OPERATION Manual Table of Contents Introduction IntroductionToxic Fluid Hazard Safety WarningsMedical Treatment Always ground all of these components Flushing When Testing for Spark Before Performing Adjustments or RepairsLock Trigger to Remove Spray TIP Control Valve How to FlushFlushing Flush the sprayer Setting Up to Stripe or SprayConnect the hose and gun Remove the snap-on cover plate over the piston GroundingDaily Maintenance Pressure Relief ProcedureHandle the Spray System AS YOU Would a Loaded Firearm Starting UpChoose handle location Striping OperationOrifice Size Inches Striping Tip GuideStriping TIP Major Components of Spray GUN Reversible REV-TIP Spray TIP AssemblySpray Gun Operation Spray GUNTest the Pattern Correction Spray Gun TroubleshootingDefects Cause Problem Cause Solution Field TroubleshootingFluid Pump Disconnect Servicing the Fluid PumpServicing the Piston Rod Outlet Valve Servicing the Suction AssemblyReplacement Instructions Packing Replacement ProceduresPacking Replacement Procedures Inspection & Replacement of Control Valve, Ball & Seat Part Number Description Gear Box Assembly Part NoGun Mount Assembly Part No Spray Gun Assembly Part NoPart Number Description Qty Bypass Valve Assembly Part NoSuction Assembly Part No Frame Assembly Part No Quick F Accessoriesairlessco
Top Page Image Contents