Using Paper Drilling Template

Page 6

1. Place paper template lettering up onto top side of router table or inset plate.

2. Router table fence reference line. Setting this line parallel with the back

edge of the router table or insert plate positions the router so the

Router Raizer access hole will be drilled out in front of the fence.

3. Center cross hairs. Accurately center this point in the hole of the

Refer to pages 4,5,6 before using template

router table or insert plate, using a pencil compass or tape measure.

Tape in place and recheck before drilling holes.

Additional Templates Available on Website

4. Router mounting holes. For highest accuracy place the routers

original subbase over the templates router mounting holes and

tape subbase down. Use a Vix bit, center punch or drill bit to

transfer holes to the router table or insert.

3/4" reference circle for drilling the routers original subbase only. Table mounted, drill 1/2" hole in table top.

1/2" = .500

.500" reference circle for drilling table top or insert plate.

		5. Router Raizer access hole. Use page 4 and # 46 locating pin to
		accurately mark the access hole location
		accurately mark the access hole location
		WARNING: IF 3/4" POCKET IS REQUIRED PAGES 4 & 5. DO NOT
		DRILL 3/4" HOLE COMPLETELY THROUGH THE TABLE TOP OR
Router Raizer access hole		INSERT PLATE. A 1/2" HOLE IS REQUIRED IN THE TOP TO
Router Raizer access hole		ACCEPT THE #30 DUST COVER INSERT.
	Drill .500" hole	IF ORIGINAL SUBBASE IS USED BETWEEN ROUTER AND TABLE
	table insert plate	PAGES 4 & 5. USE #46 LOCATING PIN THEN DRILL 3/4" HOLE
	through router
install #30 dust cover insert		THROUGH ORIGINAL SUBBASE.
into .500" hole and press flush
with top of insert plate

NOTE: This hole must be drilled 1/2" or .500" for #30 dust cover insert to fit properly.

Use this 6" scale to check accuracy when copied

6" Scale. If template is copied or downloaded from web site, use this scale to accurately check template size.

Problem	Cause	Solution

Router Raizer will not	#19 or #20 Drive nut loose	The drive nut cannot rotate, Retighten the drive nut on router.
raise or lower the router
	Router plunge posts dry	Clean posts and lubricate with STP® MOTOR OIL TREATMENT

Router Raizer Speed Wrench	Pocket in table top or insert plate	Check pocket depth and deepen if necessary.
turns hard	not counter sunk deep enough	#1 mainshaft head must rotate freely.

	#21 lead screw has no lubrication	Re lubricate using supplied red grease or heavy wheel bearing grease.

	Router plunge posts dry	Clean posts and lubricate with STP® MOTOR OIL TREATMENT

Router Raizer will not	Turret stop on router improperly set	Locate rotating turret stop on base of router and adjustable stop
Router Raizer will not		directly above. Adjustable stop must be retracted as high as possible.
raise router high enough
raise router high enough		Turret stop must be rotated so shortest post is under adjustable stop.


	Reached maximum	All plunge routers have a predetermined plunge stroke, the Router-
	plunge depth of router	Raizer will not increase this stroke. With router fully compressed-
		check amount of plunge post still visible. 1/16" to 1/4" post should
		be visible.
		If more than 1/16" to 1/4" of post is visible, Call 1-866-266-1293
		Addition of a collet extension is required to safely run some bits.

Router becomes harder	Router plunge posts dry	Clean posts and lubricate with STP® MOTOR OIL TREATMENT
to raise and lower

Makita RZ 100 installation instructions Using Paper Drilling Template, Problem Cause Solution